Ipv6 pim-sm non-scoped zone configuration example, Network requirements, Configuring ipv6 multicast routing and forwarding – H3C Technologies H3C S12500-X Series Switches User Manual
Page 186: Configuring the rpf route selection rule
176
2: Vlan-interface102
Protocol: pim-dm, UpTime: 00:02:19, Expires: -
IPv6 PIM-SM non-scoped zone configuration example
Network requirements
As shown in
:
•
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub
networks, and at least one receiver host exist in each stub network. The entire IPv6 PIM-SM domain
contains only one BSR.
•
Host A and Host C are multicast receivers in the stub networks N1 and N2.
•
VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The
C-BSR on Switch E has a higher priority. The C-RPs are designated to the IPv6 multicast group range
FF0E::101/64. Modify the hash mask length to map the IPv6 multicast group range to the two
C-RPs.
•
MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 54 Network diagram
Table 12 Interface and IPv6 address assignment
Device Interface
IPv6 address
Switch A
VLAN-interface 100
1001::1/64
Switch A
VLAN-interface 101
1002::1/64
Switch A
VLAN-interface 102
1003::1/64
Etherne
t
Eth
ernet
Ethern
et
N1
N2
Vlan-
int101
Vlan-
int
101
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module