H3C Technologies H3C S12500-X Series Switches - Manual (Page 134)

124
Figure 39 Network diagram
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 39 . (Details not
shown.)
2. Configure Router A:
# Enable IPv6 multicast routing.
system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
# Enable MLD on Ten-GigabitEthernet 1/0/1.
[RouterA] interface ten-gigabitethernet 1/0/1
[RouterA-Ten-GigabitEthernet1/0/1] mld enable
[RouterA-Ten-GigabitEthernet1/0/1] quit
# Enable IPv6 PIM-DM on Ten-GigabitEthernet 1/0/2.
[RouterA] interface ten-gigabitethernet 1/0/2
[RouterA-Ten-GigabitEthernet1/0/2] ipv6 pim dm
[RouterA-Ten-GigabitEthernet1/0/2] quit
3. Configure Switch A:
# Enable MLD snooping globally.
system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/3 to
the VLAN, and enable MLD snooping for the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ten-gigabitethernet 1/0/1 to ten-gigabitethernet 1/0/3
[SwitchA-vlan100] mld-snooping enable