Igmp snooping configuration examples, Group policy configuration example, Network requirements – H3C Technologies H3C S12500-X Series Switches User Manual
Page 39: Configuration procedure, Configuring static ports

29
Task Command
Remove dynamic router ports.
reset igmp-snooping router-port { all | vlan vlan-id }
Clear statistics for the IGMP messages
learned by IGMP snooping.
reset igmp-snooping statistics
IGMP snooping configuration examples
Group policy configuration example
Network requirements
As shown in
, Router A runs IGMPv2 and serves as the IGMP querier. Switch A runs IGMPv2
snooping.
Configure a group policy and simulate joining to achieve the following goals:
•
Host A and Host B receive only the multicast data addressed to the multicast group 224.1.1.1.
•
Switch A drops unknown multicast data instead of flooding it in VLAN 100.
Figure 13 Network diagram
Configuration procedure
1.
Assign an IP address and subnet mask to each interface according to
shown.)
2.
On Router A:
# Enable IP multicast routing globally.
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable IGMP on Ten-GigabitEthernet 1/0/1.
[RouterA] interface ten-gigabitethernet 1/0/1
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module