Ipv6 pim-ssm configuration example, Network requirements, Mldv2 enhancements – H3C Technologies H3C S12500-X Series Switches User Manual
Page 195

185
1002::2 (local) 192 180 00:02:03 00:02:56
Group/MaskLen: FFF4::/16
RP address Priority HoldTime Uptime Expires
1002::2 (local) 192 180 00:02:03 00:02:56
Group/MaskLen: FF04::/16
RP address Priority HoldTime Uptime Expires
1002::2 (local) 192 180 00:02:03 00:02:56
# Display RP information on Switch F.
[SwitchF] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: FF00::/8
RP address Priority HoldTime Uptime Expires
8001::1 (local) 192 180 00:10:28 00:02:31
IPv6 PIM-SSM configuration example
Network requirements
As shown in
:
•
Receivers receive VOD information through multicast. The receiver groups of different organizations
form stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM
domain operates in the SSM mode.
•
Host A and Host C are IPv6 multicast receivers in two stub networks N1 and N2.
•
The SSM group range is FF3E::/64.
•
MLDv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module