Configuring common pim timers globally, Configuring common pim timers on an interface, Pim-dm overview – H3C Technologies H3C S12500-X Series Switches User Manual
Page 95

85
current interface. If you configure common PIM timers in both PIM view and interface view, the
configuration in interface view always takes precedence.
TIP:
For a network without special requirements, H3C recommends that you use the defaults.
Configuring common PIM timers globally
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter PIM view.
pim [ vpn-instance
vpn-instance-name ]
N/A
3.
Set the interval to send hello
messages.
timer hello interval
The default setting is 30 seconds.
4.
Set the interval to send
join/prune messages.
timer join-prune interval
The default setting is 60 seconds.
NOTE:
This configuration takes effect after
the current interval ends.
5.
Set the joined/pruned state
holdtime timer.
holdtime join-prune time
The default setting is 210 seconds.
6.
Set the multicast source
lifetime.
source-lifetime time
The default setting is 210 seconds.
Configuring common PIM timers on an interface
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Set the interval to send hello
messages.
pim timer hello interval
The default setting is 30 seconds.
4.
Set the maximum delay for
sending a hello message.
pim triggered-hello-delay delay
The default setting is 5 seconds.
5.
Set the interval to send
join/prune messages.
pim timer join-prune interval
The default setting is 60 seconds.
NOTE:
This configuration takes effect after
the current interval ends.
6.
Set the joined/pruned state
holdtime timer.
pim holdtime join-prune time
The default setting is 210 seconds.
Setting the maximum size of each join or prune message
The loss of an oversized join or prune message might result in loss of massive information. You can set a
small value for the size of each join or prune message to reduce the impact.
To set the maximum size of each join or prune message:
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module