beautypg.com

Solution, Multicast group filter does not work, Symptom – H3C Technologies H3C S12500-X Series Switches User Manual

Page 44: Analysis, Enabling dropping unknown multicast data

background image

34

Solution

1.

Use the display igmp-snooping command to display IGMP snooping status.

2.

If IGMP snooping is not enabled, use the igmp-snooping command in system view to enable IGMP
snooping globally, and then use the igmp-snooping enable command in VLAN view to enable
IGMP snooping for the VLAN.

3.

If IGMP snooping is enabled globally but not enabled for the VLAN, use the igmp-snooping enable
command in VLAN view to enable IGMP snooping for the VLAN.

Multicast group filter does not work

Symptom

Hosts can receive multicast data from multicast groups that are not permitted by the multicast group filter.

Analysis

The ACL is incorrectly configured.

The multicast group filter is not correctly applied.

The function of dropping unknown multicast data is not enabled, so unknown multicast data is
flooded.

Solution

1.

Use the display acl command to verify that the configured ACL meets the multicast group filter
requirements.

2.

Use the display this command in IGMP-snooping view or in a corresponding interface view to
verify that the correct multicast group filter has been applied. If not, use the group-policy or

igmp-snooping group-policy command to apply the correct multicast group filter.

3.

Use the display igmp-snooping command to verify that the function of dropping unknown multicast
data is enabled. If not, use the drop-unknown or igmp-snooping drop-unknown command to

enable the function of dropping unknown multicast data.