beautypg.com

Configuring ipv6 pim-dm, Ipv6 pim-dm configuration task list, Configuration prerequisites – H3C Technologies H3C S12500-X Series Switches User Manual

Page 167: Enabling ipv6 pim-dm, Configuring ipv6 multicast source port filtering

background image

157

RFC 5059, Bootstrap Router (BSR) Mechanism for Protocol Independent Multicast (PIM)

RFC 4607, Source-Specific Multicast for IP

Draft-ietf-ssm-overview-05, An Overview of Source-Specific Multicast (SSM)

Configuring IPv6 PIM-DM

This section describes how to configure IPv6 PIM-DM.

IPv6 PIM-DM configuration task list

Task at a glance

(Required.)

Enabling PIM-SM

(Optional.)

Enabling the state refresh feature

(Optional.)

Configuring state refresh parameters

(Optional.)

Configuring IPv6 PIM-DM graft retry timer

(Optional.)

Configuring common IPv6 PIM features

Configuration prerequisites

Before you configure IPv6 PIM-DM, configure an IPv6 unicast routing protocol so that all devices in the

domain are interoperable at the network layer.

Enabling IPv6 PIM-DM

Enable IPv6 multicast routing before configuring IPv6 PIM.
With IPv6 PIM-DM enabled on interfaces, routers can establish IPv6 PIM neighbor relationship and

process IPv6 PIM messages from their IPv6 PIM neighbors. When you deploy an IPv6 PIM-DM domain,

H3C recommends that you enable IPv6 PIM-DM on all non-border interfaces of routers.

IMPORTANT:

All the interfaces on a device must operate in the same IPv6 PIM mode in the public network or the same
VPN instance.

To enable IPv6 PIM-DM:

Step

Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enable IPv6 multicast routing
and enter IPv6 MRIB view.

ipv6 multicast routing
[ vpn-instance vpn-instance-name ]

By default, IPv6 multicast routing is
disabled.

3.

Return to system view.

quit

4.

Enter interface view.

interface interface-type
interface-number

N/A