beautypg.com

Configuration procedure, Configuring ipv6 multicast load splitting – H3C Technologies H3C S12500-X Series Switches User Manual

Page 187

background image

177

Device Interface

IPv6 address

Switch B

VLAN-interface 200

2001::1/64

Switch B

VLAN-interface 103

2002::1/64

Switch C

VLAN-interface 200

2001::2/64

Switch C

VLAN-interface 104

192.168.3.1/24

Switch D

VLAN-interface 300

4001::1/64

Switch D

VLAN-interface 101

1002::2/64

Switch D

VLAN-interface 105

4002::1/64

Switch E

VLAN-interface 104

3001::2/64

Switch E

VLAN-interface 103

2002::2/64

Switch E

VLAN-interface 102

1003::2/64

Switch E

VLAN-interface 105

192.168.4.1/24

Configuration procedure

1.

Assign an IPv6 address and prefix length to each interface according to

Figure 54

. (Details not

shown.)

2.

Enable OSPFv3 on all switches on the IPv6 PIM-SM network to make sure the following conditions
are met: (Details not shown.)

{

The switches are interoperable at the network layer.

{

The switches can dynamically update their routing information.

3.

Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM:
# On Switch A, enable IPv6 multicast routing globally.

system-view

[SwitchA] ipv6 multicast routing

[SwitchA-mrib6] quit

# Enable MLD on VLAN-interface 100 (the interface that connects to the stub network).

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] mld enable

[SwitchA-Vlan-interface100] quit

# Enable IPv6 PIM-DM on the other interfaces.

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ipv6 pim sm

[SwitchA-Vlan-interface101] quit

[SwitchA] interface vlan-interface 102

[SwitchA-Vlan-interface102] ipv6 pim sm

[SwitchA-Vlan-interface102] quit

# Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM on Switch B and Switch C in the same way
Switch A is configured. (Details not shown.)
# Enable IPv6 multicast routing and IPv6 PIM-SM on Switch D and Switch E in the same way Switch
A is configured. (Details not shown.)

4.

Configure a C-BSR and a C-RP:
# On Switch D, configure the service scope of RP advertisements.