Configuration prerequisites, Configuring an ipv6 multicast data filter, Configuring a hello message filter – H3C Technologies H3C S12500-X Series Switches User Manual
Page 177

167
Configuration prerequisites
Before you configure common IPv6 PIM features, complete the following tasks:
•
Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
•
Configure IPv6 PIM-DM or IPv6 PIM-SSM.
Configuring an IPv6 multicast data filter
In either an IPv6 PIM-DM domain or an IPv6 PIM-SM domain, routers can check passing-by IPv6 multicast
data and determine whether to continue forwarding the IPv6 multicast data based on the configured
filtering rules. You can configure an IPv6 PIM router to act as an IPv6 multicast data filter to help
implement traffic control and control the information available to downstream receivers.
A filter can filter not only independent IPv6 multicast data but also IPv6 multicast data encapsulated in
register messages. Generally, a filter nearer to the IPv6 multicast source has a better filtering effect.
To configure an IPv6 multicast data filter:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter IPv6 PIM view.
ipv6 pim [ vpn-instance
vpn-instance-name ]
N/A
3.
Configure an IPv6 multicast
data filter:
source-policy acl6-number
By default, no IPv6 multicast data
filter is configured.
Configuring a hello message filter
Along with the wide applications of IPv6 PIM, the security requirement for the protocol is becoming
increasingly demanding. The establishment of correct IPv6 PIM neighboring relationship is a prerequisite
for secure application of IPv6 PIM.
To guard against IPv6 PIM message attacks, you can configure a legal source address range for hello
messages on interfaces of routers to ensure the correct IPv6 PIM neighboring relationship.
To configure a hello message filter:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure a hello message
filter.
ipv6 pim neighbor-policy
acl6-number
By default, no hello message filter
exists.
If an IPv6 PIM neighbor's hello
messages cannot pass the filter, the
neighbor is automatically removed
when its maximum number of hello
attempts is reached.
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module