beautypg.com

Configuration task list, Enabling ipv6 multicast routing, Configuring ipv6 multicast routing and forwarding – H3C Technologies H3C S12500-X Series Switches User Manual

Page 140: Configuring the rpf route selection rule

background image

130

searches its IPv6 unicast routing table and finds that the outgoing interface to the source (the RPF

interface) is VLAN-interface 20. This means that the (S, G) entry is correct but the packet traveled
along a wrong path. The RPF check fails and the router discards the packet.

Configuration task list

Tasks at a glance

(Required.)

Enabling IPv6 multicast routing

(Optional.)

Configuring IPv6 multicast routing and forwarding

(Optional.)

Configuring the RPF route selection rule

(Optional.)

Configuring IPv6 multicast load splitting

(Optional.)

Configuring an IPv6 multicast forwarding boundary

(Optional.)

Configuring static multicast MAC address entries

Enabling IPv6 multicast routing

Enable IPv6 multicast routing before you configure any Layer 3 IPv6 multicast functionality in the public

network or VPN instance.
To enable IPv6 multicast routing:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enable IPv6 multicast routing
and enter IPv6 MRIB view.

ipv6 multicast routing
[ vpn-instance vpn-instance-name ]

By default, IPv6 multicast routing is
disabled.

Configuring IPv6 multicast routing and forwarding

Before you configure IPv6 multicast routing and forwarding, complete the following tasks:

Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
network layer.

Configure IPv6 PIM-DM or IPv6 PIM-SM.

Configuring the RPF route selection rule

You can configure the router to select the RPF route based on the longest prefix match principle. For more

information about RPF route selection, see "

RPF check process

."

To configure an IPv6 multicast routing policy:

Step Command

Remarks

1.

Enter system view.

system-view

N/A