Configuring static ports, Configuration procedure, Configuring pim hello message options – H3C Technologies H3C S12500-X Series Switches User Manual
Page 124
114
Setting the aging timers for dynamic ports globally
Step Command
Remarks
1.
Enter system view.
system-view N/A
2.
Enter MLD-snooping view.
mld-snooping
N/A
3.
Set the aging timer for
dynamic router ports globally. router-aging-time interval
The default setting is 260 seconds.
4.
Set the aging timer for
dynamic member ports
globally.
host-aging-time interval
The default setting is 260 seconds.
Setting the aging timers for the dynamic ports in a VLAN
Step Command
Remarks
1.
Enter system view.
system-view N/A
2.
Enter VLAN view.
vlan vlan-id
N/A
3.
Set the aging timer for
the dynamic router ports
in the VLAN.
mld-snooping router-aging-time
interval
The default setting is 260 seconds.
4.
Set the aging timer for
the dynamic member
ports in the VLAN.
mld-snooping host-aging-time
interval
The default setting is 260 seconds.
Configuring static ports
If all hosts attached to a port are interested in the IPv6 multicast data addressed to a particular IPv6
multicast group or the IPv6 multicast data that a particular IPv6 multicast source sends to a particular IPv6
multicast group, you can configure the port as a static member port for the specified IPv6 multicast group
or the specified IPv6 multicast source and group.
You can also configure a port as a static router port, through which the switch can forward all IPv6
multicast traffic it receives.
When you configure static ports, follow these guidelines:
•
A static member port does not respond to queries from the MLD querier. When you configure a port
as a static member port or cancel this configuration on the port, the port does not send unsolicited
MLD reports or MLD done messages.
•
Static member ports and static router ports never age out. To remove such a port, use the
corresponding undo command.
Configuration procedure
To configure static ports:
Step Command
Remarks
1.
Enter system view.
system-view N/A
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module