A2.2 mtp link set – Welltech SPCI2S Intel NetStructure SS7 Boards User Manual
Page 98
SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2
Page 98
A2.2 MTP Link Set
Syntax: MTP_LINKSET
Example: MTP_LINKSET 0 321 2 0x0000 456 0x8
Configuration of a link set to an adjacent signalling point.
The logical identity of the link set, in the range 0 to one less than the number of link sets supported,
The linkset_id is used in other commands for reference.
The signalling point code of the adjacent signalling point.
The number of links to be allocated to the link set.
A 16 bit value reserved for future use to specify run time options. Currently no options are defined so
the parameter must be set to zero.
The signalling point code of the signalling point itself.
The value to be used in the sub-service field of all level 3 messages and checked for by the
discrimination function in all received messages. This is a 4 bit value. Note that for ANSI operation
both of the two least significant bits should be set to 1.
NOTE: For correct operation the adjacent point code must also appear in a MTP_ROUTE
declaration.