Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 19)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 19
b) REDIRECT commands to cause messages generated for modules not running
locally to be redirected via a module that is running locally.
c) FORK_PROCESS commands advising gctload of any processes that need to be
started locally.
The full syntax of each command is listed in the Software Environment
Programmer’s Manual.
An example system.txt file is shown below:
*
* Example system.txt for the Development Package for Windows.
*
* Edit this file to reflect your configuration.
*
* Essential modules running on host:
*
LOCAL
0x20 * ssd/ssds - Board interface task
LOCAL 0x00 * tim_nt - Timer task
*
* Optional modules running on the host:
*
LOCAL
0xcf * s7_mgt - Management/config task
LOCAL 0x2d * upe - Example user part task
*
* Modules running on the board (all redirected via ssd):
*
* REDIRECT 0x23 0x20 * ISUP module
* REDIRECT 0x4a 0x20 * TUP module
* REDIRECT 0x33 0x20 * SCCP module
* REDIRECT 0x14 0x20 * TCAP module
* REDIRECT 0x15 0x20 * MAP module
* REDIRECT 0x25 0x20 * IS41 module
REDIRECT
0x22 0x20 * MTP3 module
REDIRECT 0x71 0x20 * MTP2 module
REDIRECT 0x10 0x20 * CT bus/Clocking control module
REDIRECT 0x8e 0x20 * On-board management module
*
* Redirection of status indications:
*
REDIRECT
0xdf 0x2d * LIU/MTP2 status messages -> upe
REDIRECT 0xef 0x2d * Other indications -> upe
*
* Now start-up all local tasks:
*
FORK_PROCESS ssds.exe
FORK_PROCESS tim_nt.exe
FORK_PROCESS tick_nt.exe
FORK_PROCESS s7_mgt.exe
FORK_PROCESS upe.exe
*