Welltech SPCI2S Intel NetStructure SS7 Boards User Manual
Page 27

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2
Page 27
4. PROGRAM EXECUTION
This section describes how to start the software running. It assumes that the
software has already been installed and the configuration files system.txt and
config.txt have been modified accordingly. Refer to previous sections if unsure.
There are three main stages to getting a new application up and running although
the precise means of achieving this vary slightly depending upon the operating
system.
First the device driver must be installed and run.
Secondly the protocol software running on the host must be run up.
The final stage is to write your application (making use of the examples supplied),
compile it (using the header files supplied) and link it with the supplied libraries to
generate a finished application program.
The details of how these steps are achieved for each operating system are given
below.