Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 11)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 11
2.2 Software Installation for Linux*
The Development Package for Linux is distributed either on a CD-ROM or
electronically. The distribution is in the form of a single compressed file called
dpklnx6.Z. It should be installed as follows:
1. Login and switch to a user account with root privileges.
2. Create a new directory (referred to as the install directory) to act as the root
directory for the software.
3. Copy the dpklnz6.Z file to the development system that is running Linux. Take
care that the ’.Z’ file suffix is in upper case.
4. Extract the files using the command:
tar -zxvf dpklnx6
The following files (or similar) are extracted into the current working directory, it is
recommended that you create a new directory to serve as the root directory for the
software. Note that a number of additional files relating to other products in the
range will be installed at the same time.
sptpci.o Linux device driver for the SPCI2S, SPCI4 & CPM8 cards.
gctlib.lib Library to be linked with user’s application
INC Sub-directory containing header files for use with user’s application
system.txt Example system configuration file
config.txt Example protocol configuration file
gctload
ssds
tick_lnx
tim_lnx
s7_mgt
s7_log
s7_play
mtpsl
upe Executables for use as described elsewhere in this manual
inap_api.lib INAP API library to be linked with the user’s application if it uses INAP.