Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 38)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 38
Parameter Description:
board_type
The type of board to be reset. This should be set to 2 for SPCI2S, SPCI4 and
CPM8 boards.
phy_id
The physical id for the board. This field should be set to the same value as the
board_id. (ie 0 .. one less than the number of boards supported).
code_file
Null terminated string giving the filename of the code file to be downloaded to
the board.
run_mode
Number taken from the following table to indicate which protocols are to be run:
NOTE: It is only possible to activate protocols that have been licensed to run on
the board by use of a suitable licence button.
run_mode Mnemonic Protocols selected to run on the board
1 DTI Digital Trunk Interface only, no protocol software. This mode does
NOT require the use of a software licence button).
2 MTP2 MTP2 protocol only.
3 MTP MTP3 plus MTP2 protocols.
4 ISUP ISUP, standard version, up to 256 circuits plus all MTP.
5 ISUP-L ISUP, large version, up to 4096 circuits plus all MTP.
6 TUP TUP, standard version, up to 256 circuits plus all MTP.
7 TUP-L TUP, large version, up to 4096 circuits plus all MTP.
10 SCCP-CL SCCP connectionless operation plus all MTP.
11 SCCP-CO SCCP connection-oriented plus connectionless plus all MTP.
12 TCAP TCAP plus SCCP-CL plus all MTP.
13 ISTC ISUP standard version plus TCAP, plus SCCP-CL plus all MTP
14 MAP MAP plus TCAP plus SCCP-CL plus all MTP.
15 IS41 IS41 plus TCAP plus SCCP-CL plus all MTP.