Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 35)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 35
5.2 General Configuration Messages
5.2.1 SSD Reset Request
Synopsis:
Message sent to SSD once at initialisation to set up run-time options.
NOTE: When using s7_mgt, this message is generated by s7_mgt and should
not be generated by the user.
Message Format:
MESSAGE HEADER
FIELD NAME MEANING
type SSD_MSG_RESET (0x7680)
id 0
src Sending module’s module_id
dst SSD_TASK_ID (0x20)
rsp_req used to request a confirmation
hclass 0
status 0
err_info 0
len 24
PARAMETER AREA
OFFSET SIZE NAME
0 1 module_id - must be set to SSD_TASK_ID
1
2 reserved - set to zero
3 1 mgmt_id
4
18 reserved - set to zero
22 2 num_boards
Description:
This message is used during initialisation by the application to reset the ssd
module and set up its run-time parameters.
The confirmation message (if requested) will indicate success by a status of 0.