Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 92)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 92
Bit 13 causes the board to drive the CT_NETREF1 clocks on the CT bus when set to 1. The
highest priority in-sync line interface will be used as a clock source. If this bit is set to zero then the
CT_NETREF1 clock will not be driven. By default, liu_id=0 is the highest priority and liu_id=7 is the
lowest. The priority can however be modified using the MVD_MSG_CLK_PRI message.
All other bits are reserved and should be set to zero.
The name of the code file which gets downloaded to the board when it is reset. Code files for
SPCI2S, SPCI4 and CPM8 boards all use the suffix .dc3. All SS7 protocols are included in a single
code file called ss7.dc3. The selection of which protocols are run is made using the run_mode
parameter below.
The run_mode determines which protocols are invoked at run time. should be set to
one of the following tokens depending on the protocols that are required to run on the board (note
that only protocols permitted to be run by the software licence will be allowed to run):
run_mode Protocols selected to run on the board
DTI Digital Trunk Interface only, no protocol software. This mode does
NOT require the use of a software licence button).
MTP2 MTP2 protocol only.
MTP MTP3 plus MTP2 protocols.
ISUP ISUP, standard version, up to 256 circuits plus all MTP.
ISUP-L ISUP, large version, up to 4096 circuits plus all MTP.
TUP TUP, standard version, up to 256 circuits plus all MTP.
TUP-L TUP, large version, up to 4096 circuits plus all MTP.
SCCP-CL SCCP connectionless operation plus all MTP.
SCCP-CO SCCP connection-oriented plus connectionless plus all MTP.
TCAP TCAP plus SCCP-CL plus all MTP.
ISTC ISUP standard version plus TCAP, plus SCCP-CL plus all MTP
MAP MAP plus TCAP plus SCCP-CL plus all MTP.
IS41 IS41 plus TCAP plus SCCP-CL plus all MTP.