Welltech SPCI2S Intel NetStructure SS7 Boards - Manual (Page 8)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 8
2.2 Software Installation for Windows*
The Development Package for Windows is distributed either on a CD-ROM or
electronically. The distribution is in the form of a single zip file (dpkwin.zip) which
should be unzipped and placed on a clean DOS format disk to replicate the normal
distribution and serve as a backup.
2.2.1 Software installation for Windows
Prior to installing a new release of the Development Package it is necessary to
remove any previous release of the package. Refer to instructions to the end of this
section.
If installing the Development Package on a target system as opposed to a machine
used only for developing an application, the user should first install the hardware.
The software is installed from the distribution disk using Install Shield
*
. The user
must have ‘Administrator’ privilege. First close all other applications then insert the
disk into the floppy disk drive of the target machine. If the target machine does not
automatically detect the installation disk then run the program 'Setup.exe' from the
distribution disk. The licence agreement must be read and accepted before
installation can proceed.
The installation procedure prompts for an installation directory. The default directory
is c:\septel. If required, the default directory can be modified.
The following files (or similar) are transferred to the installation directory. Note that
a number of additional files relating to other products in the range will be installed at
the same time.
gctlib.lib Library to be linked with user’s application (Microsoft*)
gctlibb.lib Library to be linked with user’s application (Borland*)
INC Sub-directory containing include files
system.txt Example system configuration file
config.txt Example protocol configuration file
gctload.exe
ssds.exe
tick_nt.exe
tim_nt.exe
s7_mgt.exe
s7_log.exe
s7_play.exe
servcfg.exe
gctserv.exe
mtpsl.exe
upe.exe Executables for use as described elsewhere in this manual
inap_api.lib INAP API library to be linked with the user’s application if it uses INAP.