Skutch Electronics BA-1000 Technical Reference Manual - Manual (Page 27)

Version 6.15 Page 27
Factory Defaults
The display will show the following:
Load APP Presets
0 to 1 #=Next
Tap 0 and it will show the following for 2
seconds:
Loading Defaults
- Please Wait –
The system will then show the following:
Load APP Presets
0 to 1 #=Next
Load Application 1
The display will show the following:
Load APP Presets
0 to 1 #=Next
Tap 1 and it will show the following for 2
seconds:
Loading APP # 1
– Please Wait -
The system will then show the following:
Load APP Presets
0 to 1 #=Next
 Dial Mode= Tone
This option allows you to select touch tone
dialing or pulse dialing. Some phone lines still only
allow pulse dialing for outbound calls; in these areas
you can change the system to pulse dial mode. The
display looks as follows:
Dial Mode= Tone
1=Change #=Next
Tap the 1 to toggle between Tone and Pulse ;
or # to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Consent #= Play
This option allows you to change how the
system uses the touch tone consent mode. When
you make your outgoing message, one of the codes
you can use is the Tone Consent code. When the
system encounters a Tone Consent code during a
call, it will wait for the called party to press then
release a touch tone digit. With this option set for
Play mode, the system will continue with the
outgoing message when it receives a touch tone
input; it will hang up if it doesn’t. When set for
Stop mode, the system will hang up if it receives a
touch tone input; it will continue with the outgoing
message if it doesn’t. The display will look as
follows:
Consent #= Play
1=Change #=Next
Tap the 1 to toggle between Play and Stop; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Xfer Beeps= On
This option allows you to turn the transfer
beeps on/off. A transfer beep is a tone the system
plays to the called party after each transfer code
during message play out. When this option is On,
the system will play a beep after each question.
When Off, it won’t beep at the called party; this
makes it seem more like a live person is asking the
questions. The display will look as follows:
Xfer Beeps= On
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Pulse Rate= Slow
This option allows you to change the system
between slow pulses and fast pulses when it is in
pulse dial mode. With the option set to Slow, the
system will dial pulse digits at the standard 10
pulses-per-second rate. When set to Fast, the
system dials pulse digits at 20 pulses-per-second;
this makes for faster dialing, but not all phone
companies accept this rate. The display will look as
follows:
Pulse Rate= Slow
1=Change #=Next