Skutch Electronics CK-1P6 - Manual

Page 1 of 4
CK-1P6 Installed on
KX-TG9391 Phone
"Telecommunication Products to solve
Telecommunication Problems"
CK-1P6
Promotion-On-Hold
Module
(For Panasonic KX-TG9391T, KX-
TG9392T, KX-TG9381, KX-TG9382)
3/14/13
Introduction
Thank you for purchasing the Skutch CK-
1P6 Promotion-On-Hold Module. The
CK-1P6 is a true plug and play device. The
unit does not require any "Learning" to
operate. When a call is placed ON HOLD
from the Corded Base set, or any one of the
cordless phones, the caller will hear the
Promotion-On-Hold audio. When the line is
re-answered, the audio automatically stops.
It's that simple!
Installation
1- Position the CK-1P6 box under the base
telephone with the jacks facing towards the back of the phone. (See Fig. 1).
2- Connect the short modular cord [1&2 Phone on CK-1] to [LINE 1/2 on Phone].
3- Connect the audio cord from the AUDIO IN jack on the back of the CK-1 box, to your
audio player. If your audio player has a 1/8” phone jack, use the audio adapter on the end
of the cable.
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1].
CK-1P6
Box
Power Cube
Sensor Board
Audio Cable (RCA)
1/8” Audio Adapter
Flat Cable