Skutch Electronics BA-22 - Manual

• Introduction
The BA-22 is a bi-directional Telephone Line Simulator that provides
actual CO Dial tone, Busy, and Ringback tones. It also provides standard 48
volts "On Hook" Voltage. The BA-22 will allow either channel to "RING
UP" the other. The BA-22 has an adjustable DIAL TONE option, that allows
you to select from "No dial tone", to 2, 4, or 6 seconds of dial tone, before
the unit starts to ring up the other channel. The BA-22 has a Bi-directional
AUDIO jack for recording or playing audio. The BA-22 also provides you
with "WINK" or "CPC" disconnect upon disconnect
.
• Installation
• Operation
1) Take either side "OFF HOOK".
2) If enabled, you will get 2, 4 or 6 seconds of DIAL TONE.
3) The other side will "RING UP" and activate, you can do everything as
you normally would.
4) When you are finished, just hang up the phone.
• Recording Audio
1) Connect an audio cable from the Audio jack of the BA-22 to the MIC
jack of your tape recorder.
2) Start the tape recording when you are ready and the recorder will record
the communications betwween channel A and B.
• Play Audio into BA-22
1) Connect an audio cable from the Audio jack of the BA-22 to the
HEADPHONES or MONITOR jack of your tape player or other audio
source.
2) Place the Audio source in the play mode. The audio will be herd on both
channel A and B.
• Enabling/Disabling Dial Tone
The BA-22 is factory set to supply 4 seconds of DIAL TONE. To
change this setting, disconnect the BA-22 from power and open the BA-22
(remove 4 screws from lid).
1) Find the jumpers labeled J1 and J2.
2) Pull the shorting blocks off of J1 and J2.
3) Put the shorting blocks on J1 and J2 for the desired DIAL TONE setting.
4) Reassemble the BA-22.
• Tech Support - 916-786-6186
If you have any problems getting the unit to work properly feel free to
give us a call. Technical Support is available between the hours of 7:30 AM
and 4:30 PM Pacific Time, Monday through Friday.
6 Sec Dial Tone
2 Sec Dial Tone No Dial Tone
4 Sec Dial Tone
B A -2 2
Channel Channel
Audio In/Out
A B
- Normal
- Busy
- SIT
Caution:
Panel can get very warm.
True CO Dial Tone, Busy, and Ringback tones
48v Battery
Internal Jumper
Settings