Skutch Electronics BA-1000 Technical Reference Manual - Manual (Page 28)

Version 6.15 Page 28
Tap the 1 to toggle between Slow and Fast;
or # to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Mic AGC= On
This option allows you to turn the AGC for
Mic/Line level inputs on/off. The AGC is the
automatic gain control. When this option is On, the
system will make quiet audio signals louder during
outgoing message record; this is best when using a
microphone. When this option is Off, the system
will record the audio signals exactly as it hears them;
this is best used when recording from an external
audio source (like a tape). The display will look as
follows:
Mic AGC= On
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Mic comp= On
This option allows you to turn the silence
compression for the Mic/Line level inputs on/off.
The silence compression feature makes the system
record silence when the incoming audio signal from
the Mic/Line level inputs goes lower than the trigger
threshold. When this option is On, the system will
compress the input audio that is below the threshold.
When this option is Off, the system will record the
audio “as is”, even though it may be below the
threshold. The display will look as follows:
Mic comp= On
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Play Line= Off
This option allows you to choose whether the
system mirrors the outgoing message, or the actual
phone line input, to the speaker during message play
out on each call. With this option set for Off, the
system will mirror the outgoing message to the
speaker; this makes the entire call sound clear. With
this option set On, the system will mirror the phone
line audio to the speaker; this allows you to actually
hear what the called party is saying during message
play out, but the outgoing message will sound a little
distorted to you (rest assured, the called party hears a
clear message). The display will look as follows:
Play Line= Off
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 Delete HU= On
This option allows you to turn the response file
deletion on hang ups on/off. Normally the system
will erase the current response file if it detects a
hang up during the call. When this option is Off, the
system will record all response files; even ones
where the called party has hung up. This can
potentially waste a lot of space on the drive with
response files filled with silence or other disconnect
signals; it also takes longer to get your messages off
the system because there are a lot more files to go
through. When this option is On, the system will
only record the response files where the called party
goes through all of the questions without triggering a
hang up condition. The display will look as follows:
Delete HU= On
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.
 CPC Detect= On
This option allows you to disable the system’s
ability to detect the CPC disconnect pulse sent by
some telephone companies. When set to On, the
system will, on detecting a CPC pulse, hang up on
the current phone call and log it as a Hang Up.
When set to Off, it will ignore any CPC pulses sent.
The display will look as follows:
CPC Detect= On
1=Change #=Next
Tap the 1 to toggle between On and Off; or
# to go to the next option. Tap ~ to
return to the
Total Calls screen.