Skutch Electronics CK-1R3 - Manual

Page 1 of 4
"Telecommunication Products to solve Telecommunication Problems"
CK-1R3
Promotion-On-Hold
Module
(For RCA 25255RE2-A)
V2 5/2/14
Introduction
Thank you for purchasing the Skutch
CK-1R3 Promotion-On-Hold Module.
The CK-1R3 is a true plug and play
device. The unit does not require any
"Learning" to operate. When a call is
placed ON HOLD from the base or any
one of the cordless phones, the caller
will hear the Promotion-On-Hold audio.
When the line is re-answered, the audio
automatically stops. It's that simple!
It should be noted that the 25255
telephones BEEP every 10 seconds
when placed ON HOLD. This is a
function of the telephone, NOT the CK-
1R3. This BEEP can NOT be disabled.
The BEEP will be heard along with the
Production-On-Hold Audio.
Installation
1- Position the CK-1R3 box behind the
base telephone with the jacks facing
towards the back of the phone.
2- Disconnect the modular cord from the
back of your phone at the jack labeled
[LINE 1 + 2], and connect it to the CK-1
BOX jack labeled, [1&2 Line].
CK-1 Box
Power Cube
RCA Audio Cord
1/8” to RCA Converter
SENSOR Board
Flat Cable
Modular Phone Cable
CK-1R3 installed on 25255