Skutch Electronics BA-1000 Technical Reference Manual - Manual (Page 26)

Version 6.15 Page 26
InRing Delay= 2
1 to 9 #=Next
Enter from 1 to 9 to choose from 1 to 9
rings before the system grabs the in coming call; or
# to go the next option. Tap ~ to exit
setup mode.
 Redials= 02
This option tells the system how many times it
can re-call No Answers and Busies. The system
only performs redials after it has called the last entry
in the file. The display will look as follows:
Redials= 02
00 to 99 #=Next
Enter from 00 to 99, 00 doesn’t allow
the system to do any redials; or # to go to the next
option. Tap ~ to exit setup mode.
 Talk Limit= 30
This option tells the system how many seconds
of continuous talking it can accept, before it
considers the call a Recorded Message. For this
option, 1 = 1 second. The display will look as
follows:
Talk Limit= 30
00 to 99 #=Next
Enter from 01 to 99, or # to go to the
next option. Tap ~ to exit setup mode.
 Pre-Dial String
This option allows you to enter a master dialing
string that the system will dial before it dials each
phone number. You cannot put a partial dialing
code in the pre-dial string. You would typically use
the pre-dial string to dial the Per Call Blocking code
to disable Caller ID. The display will show the
following for 1 second, show the string for 1 second
and keep repeating.
Pre-Dial String
1=Change #=Next
The pre-dial string consists of 2 strings, 16
digits in length, each; this string was expanded due
to customer input on the need to dial special long
distance service codes. You can tap # to go to the
next option, or tap 1 to change the string, and it
will show the following:
Enter NEW String
Enter the new string followed by #, and it will
show the following:
1=Add 2 nd String
3=Next option
Now you can tap the 1 to add a 2
nd
string, up
to 16 digits, or 3 to continue. Tap ~ to
exit setup mode.
 Total Calls
This entry shows the master total phone calls
the system has processed. This can only be reset at
the factory. The display will look as follows:
- Total Calls -
----00000000----
Tap # or ~ to return to MENU.
You can access the secondary setup, while it shows
the Total Calls, by entering: *, *, *, *, #.
Secondary Setup
The secondary setup contains setting that
should only be changed by experienced users. It is
entered, from the
Total Calls window in * System
Setup, by entering: *, *, *, *, #.
 Load APP Presets
This option allows you to reset the system back
to factory defaults or load the settings for a
predefined application. The display will look as
follows:
Load APP Presets
0 to 1 #=Next
Tap the 0 to load the defaults, 1 to load the
Patient Reminder application settings or # to
proceed to the next option. Tap ~ to return
to the
Total Calls screen.