See in, Ring delay, Answer detect mode=2 – Skutch Electronics BA-1000 Technical Reference Manual User Manual
Page 25: Attended= off, Unanswer ques= 1, Inring delay= 2, 0 = normal mode, 1 = hello mode, 2 = answering machine only mode, 3 = htad mode

Version 6.15
Page 25
0 = Normal Mode
Normal mode allows the system to activate on a
“Hello” response, a “Business” intro and an
“Answering Machine” message.
1 = Hello Mode
Hello mode makes the system activate only on
a “Hello” response; any other responses causes the
system to proceed to the next call.
2 = Answering Machine Only
Mode
Answering Machine Only mode makes the
system activate only to the message response period
of an answering machine; any other response causes
the system to proceed to the next call.
3 = HTAD Mode
Hello and Answering Machine mode makes the
normal message play when someone says “Hello”; it
also gives your answering machine message to any
response longer than a “Hello”. Be aware that this
will cause the system to activate on most recorded
messages and business introductions as well.
Attended= Off
This option allows you to use the system in an
operator attended mode. Normally, the system
makes the calls unattended and gets the responses; if
you want a live operator to talk with the called party,
you can use attended mode. The display will look as
follows:
Attended= Off
0 to 3 #=Next
Enter 0 for Unattended, 1 for Front
Attended, 2 for End Attended, 3 for Both
Attended or # to go to the next option. Tap
~ to exit setup mode.
When attended mode is enabled, the system
will beep at you, when a response is detected, and
wait for you to grab the line; it will show the
following message:
Operator-Press #
& Pick up Phone.
Press the # to stop the beeping, then grab the
phone to talk with the person. When you grab the
phone, the system will wait for you to tell it what to
do next; it will show the following message:
1=Play Message
3=Do Next Call
When you are done, just hang up the phone and
tap the 1 to play the message (only during front
attended) or 3 to drop the call and proceed to the
next call.
0 = Unattended
Unattended mode is used when you don’t want
an operator to talk with the called party.
1 = Front Attended
Front attended is used to have an operator talk
with the called party before the message is played
out.
2 = End Attended
End attended is used to have an operator talk
with the called party after the message has played.
3 = Both Attended
Both attended is used to have an operator talk
with the called party both before the message is
played and after it is played.
Unanswer Ques= 1
This option allows you to set how many
unanswered questions the system will accept before
considering the call a hang up. The display will look
as follows:
Unanswer Ques= 1
1 to 9 #=Next
Enter from 1 to 9 to choose from 1 to 9
unanswered question before the call is a hang up; or
# to go the next option. Tap ~ to exit
setup mode.
InRing Delay= 2
This option allows you to select how many in
coming rings the system will wait before it activates,
when in Order Taking mode. The display will look
as follows: