Seaward ClareHAL - Manual (Page 65)

64
Use the encoder to highlight a field to be changed and press Green to
select the desired option. Use the fast key to highlight the desired
field, and the encoder to cycle through the range of permissible values
for the test parameter. Use the fast key to enter the value. To exit this
editing phase, select the OK fast key. Changes will be stored to the
system. These fields have been described in detail under the Default
Test Settings section.
Name:
Each Sequence is given a name (this case DFLT AC HIPOT); this is to
help the user when selecting Sequences during automatic testing.
When Name is highlighted press Green, and then use the encoder to
enter a new name for the Test Sequence (of up to 15 characters) and
press Green again to confirm.
Test Parameter Fields
By selecting one of the test parameter fields from the Test Settings
Editor, the encoder will cycle through all the available values for the
test parameter.
Use the Green button to save the settings and return to the Test
Settings Editor. Pressing Red will abort changes made to the settings
and return to the Test Settings Editor.
Test codes
Use the encoder and Green button to select one of the Test code
fields. A Test code can be entered manually or through a compatible
barcode scanner, reader or wand (see How to use a Barcode Scanner).
Store Settings
Use the encoder to highlight the OK field and press Green to save the
settings and return to the previous menu. Pressing Red will abort all of
the changes made and return to the previous menu.
Print Test codes
The test codes can be printed using a compatible printer - See Chapter
6 for accessories.
Use the Green button to start the print. The following message will be
displayed: -
Your HAL tester