Seaward ClareHAL - Manual (Page 10)

9
Warning
Due to the potential hazards associated with any electrical
circuit it is important that the user is familiar with the
instructions covering the capabilities and operation of this
instrument. The user should ensure that all reasonable safety
precautions are followed and if any doubt exists should seek
advice before proceeding.
This product is designed for use by suitably trained competent
personnel and should be operated strictly in accordance with
the instructions supplied.
Failure to comply with these instructions may expose the user to
electrical hazard
This Tester performs a number of electrical tests, which involve high
voltages and high currents. N
Never touch the Product being tested, or
the test leads, whilst a test is in progress. N Never remove the metal
enclosure and touch any internal components whilst the tester is
turned ON.
Always check all test leads for signs of damage prior to use. Never use
damaged or defective leads.
Always ensure the mains supply to the Tester provides an adequate
earth (ground) connection.
This manual contains information and warnings, which must be heeded
to ensure user safety during operation. It is essential that this manual
be read fully before proceeding with any tests.
Should the Tester behave abnormally do not continue with the testing.
Disconnect immediately and contact Seaward Group for servicing (see
Chapter 5 - Maintaining the Tester).
It is recommended that the correct operation of the HAL is checked at
regular
intervals by testing against an appropriate
Calibration/Checkbox or various test objects with known performance.
Your HAL tester