Seaward AGL-5 - Manual

AGL-5
Airfield Ground
Lighting Tester
Operating Instructions
Bracken Hill
South West Industrial Estate
Peterlee
Co Durham
SR8 2SW
ENGLAND
Tel: +44(0)191 5863511
www.seaward.co.uk
[email protected]
[email protected]
Part Number 374AA550 Revision 1
© 2009 Seaward Electronic Ltd
Limited Warranty & Limitation of Liability
SEAWARD Electronic Limited guarantees this product to be free
from defects in material and workmanship under normal use and
service for a period of 1 year. The period of warranty will be
effective at the day of delivery.
(c) Copyright 2009
All rights reserved. Nothing from this edition may be multiplied, or
made public in any form or manner, either electronically,
mechanically, by photocopying, recording, or in any manner,
without prior written consent from SEAWARD Electronic Limited.
This also applies to accompanying drawings and diagrams.
Due to a policy of continuous development SEAWARD Electronic
Limited reserves the right to alter the equipment specification and
description outlined in this publication without prior notice and no
part of this publication shall be deemed to be part of any contract
for the equipment unless specifically referred to as an inclusion
within such contract.
DECLARATION OF CONFORMITY
As the manufacturer of the apparatus listed, declare under our sole
responsibility that the product:
AGL-5 Airfield Ground Lighting Tester
To which this declaration relates are in conformity with the relevant
clauses of the following standard:
BS EN 61243-2:1998
BS EN 61243-3:1999
BS EN 61326:1998
Electrical equipment for measurement, control and laboratory
user-EMC Requirements
Performance: The instrument operates within specification
when used under the conditions in the above
standards EMC and Safety Standards.
The product identified above conforms to the requirements of
Council Directive 89/336/EEC and 73/23 EEC.
Seaward Electronic Ltd is registered under BS EN ISO9001:2000
Certificate No: Q05356.
1 Important Information
These operating instructions are intended for the use
of adequately trained personnel.
Before use, ensure that the AGL-5 tester is clean and
dry; visually inspect all parts. Any damage must be
rectified prior to use.
Never hold an AGL-5 Tester between the hand-
guard and the contact electrode.
Always prove the AGL-5 Tester before AND after
use.
1. Holding the AGL-5 tester by the handles,
behind the handguards, connect the
instrument to a Seaward PH3-LLT proving
unit and verify that the LED indicators are
illuminated.
2. Holding the AGL-5 tester by the handles,
behind the handguards, place the contact
electrodes in contact with the circuit
under test.
3. If the LED indicators are illuminated there
is a voltage greater than the threshold
voltage present at the probe tips.
4. If the LED indicators do not illuminate any
voltage present at the probe tips is less
than the threshold voltage.
5. Repeat step 1 above to verify that the
instrument is still operational.