Seaward ClareHAL - Manual (Page 35)

34
For all units: -
The last icon denotes the S
Start conditions for the test. They are as Fig.
1. Reset E
External safety guard switch to ‘Closed’, followed by
pressing G Green to start each repeat of the test. (Start Ext+Green)
2. Reset E External safety guard switch to ‘Closed’, followed by
pressing Green once to start the test (1 st loop). N No subsequent
pressing of Green button needed for any repeat tests. Repeat
loops will immediately convene whilst guard switch is closed.
(Start Ext+Green) for 1
st loop & (Start None) on any repeats.
3. Reset E External safety guard switch to ‘Closed’ to start test and
each repeat of the test. (Start Ext)
4. Reset E External safety guard switch to ‘Closed’ to start the test
cycle. N No subsequent stimulus needed for repeat tests. Repeats
will automatically be performed, whilst the safety guard is closed.
(Start Ext) for 1
st loop & (Start None) on any repeats
5. Press G Green to start test and each repeat of the test. External
safety guard switch must remain closed for test to begin. (Start
Green)
6. Press G Green once to start test. N No subsequent stimulus needed for
any repeat loop tests. Repeat loop tests will automatically start.
External safety guard switch must remain closed for test to begin.
(Start Green) for 1
st loop & (Start None) on any repeats.
7. N No start stimulus required. The test begins immediately after the
product data has been entered. This mode is usually a follow-on
test from a previous test.
Use this with caution . (Start None) for all
tests
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig.7
Your HAL tester