NavCom StarUtil Rev.G - Manual (Page 93)

StarUtil User Guide – Rev. G
NCT Binary Messages
NCT Binary Message Output List: Add, Configure, or Delete Messages
„ Open Message Output List
9 Select Receiver > Messages > NCT output from the menu bar. The NCT Binary Messages
window opens with the current message output list (see Figure 86).
7-91
Figu NCT Binar utput List
‡
After making an tting ions ck the Apply button and then
click the Retriev tton at ccepts the settings.
„ Add Messages
9 Right-click in a blan ss me
opens with a list of c on g
Figure 87).
9 Click on a message in the m t to
or click Other to type in the hex ID of a message.
ate is On Change. Refer to the
the port and/or rate if
Figure 87: NCT Binary Message ID Menu
re 86: y Message O
y se s in the sect below, cli
e bu to confirm th the receiver a
k Me age ID cell. A nu
omm ly used messa es (see
enu to add i the list
Message IDs are defined in the Technical
Reference Manual.
‡
The default port of a new message is Control,
and the default r
next section to configure
necessary.