NavCom StarUtil Rev.G - Manual (Page 79)

StarUtil User Guide – Rev. G
Alternate StarFire
™ Satellite
Select this option to manually force the receiver to use a
licensed StarFire
™ satellite or user-defined satellite in
case of poor reception or during routine maintenance of
the StarFire™ Network.
‡
The automatic satellite selection is based on the
license type and current GPS position.
Figure 75: StarFire Satellite ID Window
9 Select Receiver > Setup > StarFire™ > Alternate StarFire™ Satellite. The StarFire™
75).
valid satellite ID in the Alternate Satellite ID field:
(if defined).
4.2.26 and Earlier
Satellite ID window opens (see Figure
9 Click the check box to the left of Use Alternate Satellite.
9 Type in a
• An available licensed StarFire™ satellite. (Table 4 identifies StarFire™ Satellites by
Network.)
Or
• The user-defined StarFire™ satellite
Table 3: StarFire™ Satellites – Software v
Network Satellite ID Longitude
Satellite
Name
Uplink Site
402 98W PAC-E Laurentides
609 109E IND-E Perth Net 1
525 25E IND-W Burum
358 142W PAC-C Santa Paula
6-77
643 143.5E PAC-W Auckland Net 2
484 15.5W AOR-E Southbury
Table 4: StarFire™ Satellites – Software v5.1.6 and Later
Network Satellite ID Longi
Satellite
tude
Name
Uplink Site
402 97.65W PAC-E Laurentides
609 109E IND-E Perth Net 1
525 25E IND-W Burum
358 142W PAC-C Santa Paula
678 178E POR Auckland Net 2
484 15.5W AOR-E Southbury
‡
The Longitude 178E (POR) is tentatively set to change to 143.5E (PAC-W) on
May 13, 2009. The Satellite ID will also change from 678 to 643.
9 Click the check box for Ack/Nak to enable this response if desired.