NavCom StarUtil Rev.G - Manual (Page 55)

StarUtil User Guide – Rev. G
Click Use
RTK (5B, 5C, 5E)
options below:
dGPS for solution, if desired.
nd
he SBAS setting
‡
urchase of a license for the StarFire™
™ Operation
Figure 48: Rover Configuration Options
Refer to Figure 48 for the
• Require dGPS for Solution: The default is No which indicates that all computed position
solutions are output whether differentially corrected or not. Click the Yes button to
require only
• Navigation Mode: Use or ignore RTCM-104 Input (code), SBAS [WAAS/EGNOS], a
RTG Input. The default for all these navigation modes is Use. T
(RTCA/DO-229D compliant) also applies to MSAS and GAGAN. WCT input is not
applicable as of January 2008.
Access to RTG input is available only by p
subscription service. Refer to
Chapter 6 StarFire .
the navigation solution as the RTK
ropriety RTK and UltraRTK™
ual for details on messages 5B,
e fore-matter).
ly button and then click the Retrieve button to confirm that the receiver accepts
modems are turned on and the link is functional, the rover enters
e one 5C and a minimum of five
mode.
TK Corrections, to confirm that the rover is
receiving RTK corrections.
‡
dio modem and the GPS receiver. Then perform the steps in the
Corrections.
25. Click the Use button to apply RTK (5B, 5C, 5E) to
Correction Format.
‡
RTK (5B, 5C, 5E) is the setting for the NavCom p
formats. Refer to the Technical Reference Man
5C, and 5E (see Related Documents in th
26. Click the App
the settings. If the radio
into RTK mode in a few seconds. The rover needs to receiv
5B (RTK) or 5E (UltraRTK™) messages to enter RTK
27. Go to the next section, Verify Reception of NCT R
Models RT-3010 & RT-3020 only (with internal radio): Go to the section below,
Configure Internal Radio, for instructions to setup the communications between
the internal ra
next section, Verify Reception of NCT RTK
5-53