NavCom StarUtil Rev.G - Manual (Page 129)

StarUtil User Guide – Rev. G
External Device Configuration Window (Pass-Through)
The External Device Configuration window is a Pass-Through tool used to send/receive text
data from one serial port on the receiver to the other serial port. This is useful when configuring
ernal device connected to the Data, RTK, or NMEA logical port. It is also useful to
figuration window opens
(see Figure 132).
an ext
transmit ASCII text to a remote radio.
9 Select Receiver > Setup > External Radio. The External Device Con
ation Window
ally be required to enter an initial
Figure 132: External Device Configur
Initial Position
ending on Latitude & Longitude, the user may occasion
9 Select Receiver > Setup > Initial Position. The Set Receiver Position window opens. The
settings in the window apply to NCT binary message
0x46.
9 Click the Set Time box to change the elapsed time since
the beginning of the week in seconds if known. It is not
mandatory to set this field since once a satellite is tracked
GPS Week Number, and G
automatically update. After the receiver starts tracking
ce the time from the
med to be more accurate.
satellites
and acquire almanac and ephemeris information. Enter
the position in DMS or DM format. Enter the ellipsoidal
height in meters or feet.
Figure 133: Initial Position
Dep
position in order to start navigating in the shortest period of time.
Refer to Figure 133 for the steps below:
PS Week Seconds
satellites, time cannot be set sin
satellite is assu
9
Click the Set Position box to change the initial position
the receiver will use to track satellites. Typically, a
position within 500km is close enough to pickup
11-127