NavCom StarUtil Rev.G - Manual (Page 126)

StarUtil User Guide – Rev. G
Figure 127: Even er C nfiguration
lect View > B4 – Event Latch Data to view:
t Latch Message 0xB4 On Trigg o
9 Se
• Time: The time the event took place.
• Time FOM: 10x TDOP.
• Last: Shows the MM:DD:YYYY and HH:MM:SS of the last received event.
Figure 128: B4 – Event Latch Data
26).
. The
• 0xB0
message generated
• 0xB1
message generated
• 0x84 message generated
• Remaining binary messages generated
• NMEA messages generated
The binary messages have a latency of <20ms.
PPS
9 The 1PPS output can be triggered on the Falling or Rising edge of the output pulse. Set the
characteristics of the 1PPS pulse according to application requirements (see Figure 1
9 Add message 16 to the NCT Binary Messages window and set the Rate to On Change
1PPS Message 0x16 is output.
9 Select View > 84 – PPS Data to view the Time the 1PPS took place, the Time FOM, and the
Last output pulse.
‡
The process for outputting the 0x84 message and other data is:
• Signal received from satellite
10-124