NavCom StarUtil Rev.G - Manual (Page 60)

StarUtil User Guide – Rev. G
4. Click the Apply button and then click the Retrieve button to confirm that the receiver accepts
the settings.
5. Click the OK button to exit the window.
Refer to Figure 55 for the steps below:
6. Click the
Base RTCM Configuration
icon on the to transmit RTCM corrections.
The Base Configuration
‡
To open the Setup > Base.
olbar to configure the base station to
window opens.
window from the menu bar, select Receiver >
Figure 55: Base Configuration – RTCM Message Form
7. Depending on application requirements, select from the Me
at
ssage Format drop-down list:
9. T RTK Configuration, to perform the additional steps to
• RTCM 18, 19, 22 (RTK)
or
• RTCM 20, 21, 22 (RTK)
8. Do not change the defaults for:
• Obs./Correction Rate: every 1 second (the optimum rate)
• Base Position Output Rate: every 10 corrections (the optimum rate)
Go to the section above, NC
complete the base configuration. Then go to the section below, Rover RTCM Port
Configuration, to configure the rover.
5-58