NavCom StarUtil Rev.G - Manual (Page 28)

StarUtil User Guide – Rev. G
Additional Controls For CMR+
When the message format CMR+ (RTK) is selected, the Base Configuration window displays
additional controls (see Figure 11). The same controls for CMR (RTK) are not active.
Figure 11: CMR Ref Description
Refer to Figure 11 for the options below:
9 Generate CMR Ref Description: Click the check box to activate the fields.
9 Short Station ID: Enter the Short Station ID / Name.
9 COGO Code: Enter the reference station point feature code to be transmitted.
9 Ref Description: The reference station description.
RTK Base Control, Unit Port Configuration, And Antenna Setup
9 Elevation Mask: Enter the cutoff vertical angle
above the horizon. For any satellites below this
angle, no data will be transmitted to the rover for
use in calculating positions.
‡
The default recommended setting for the base
receiver is 5 degrees; however, the height of
on-site obstructions will dictate this setting.
Collecting poor data (i.e. through trees) at the
base will degrade the performance of the
rover.
Figure 12: RTK Base Control
3-26