Ch 7 - analog output window, Analog output window 7 – Measurement Computing DaqView User Manual

Page 51

Analog

Output

Window

This window provides interactive access to the analog outputs for the devices that support analog output.

When set to the default internal reference, these outputs can be set from 0 to +10 VDC.

Analog Output Window, Typical

The output voltage can be with the slide control, or by placing the cursor in the numeric field and entering

a valid voltage value. Selecting the button sends the voltage values to the outputs.
Two versions of this window exist. If a DBK2 or DBK5 is active in the Analog & Scanned Digital Input

spreadsheet, then the window will accommodate voltage and current output in addition to the DAC

reference, as indicated below. Otherwise the window will appear as in the first figure.

Analog Output Window

Special case seen with DBK2 or DBK5.

Note

: The Analog Output Window is not available when the arbitrary waveform window is visible.

DaqView User’s Guide

919194

Analog Output Window 7-1

This manual is related to the following products:

DaqView Rev.8.2 ViewXL Rev.8.2 DaqView Rev.8.3 ViewXL Rev.8.3