Measurement Computing DaqView - Manual (Page 23)

A Note about the Internal Clock Speed 100 kHz Prompt
At times [after selecting an expansion DBK] you may receive a message regarding “Internal Clock Speed.
The “Internal Clock Speed” information applies to devices that accept Analog I/O expansion. 200 kHz is
typically used.
In the Configure Systems
Hardware
screen, after
selecting a DBK, you
might be prompted to
select an internal clock
speed of 100 kHz.
(See figure).
To select an “Internal Clock Speed” of 100 kHz:
(1) Select the Acquisition Setup tab on the DaqView main window.
On the lower left corner of the window, under Scan Configuration,
click the button.
The Preferences window will appear (following figure).
Note that the Preferences window can also be accessed from the
Windows pull-down menu.
(2) Under “Internal Clock Speed,”
select 100 kHz.
(3) Click the button to return to
the DaqView main window.
This completes the clock setting
procedure.
DaqView & ViewXL User’s Guide 886994 Configure System Hardware 3-7