Measurement Computing DaqView - Manual (Page 18)

The Configure System Hardware screen appears, showing the channel assignments.
Configure System Hardware Screen
The DBKs typically have a channel address set physically on the device, by either a
switch or a header. The channel designated in software must agree with the hardware
setting. Thus, in step 2 below, Channel 0 will only be used to select a specific DBK when
that DBK is physically set for Channel 0. Refer to the specific DBK section for more
information, if needed.
2. Under Analog I/O Option Cards External Connection, select the expansion down-arrow for the
chosen Daq Device channel, for example, P1 Channel 0. A “drop-down” will list the available
analog DBK options.
An alternative to using the expansion down-arrow to access the external connection drop-
down list, is to click within the text box. For example, in the following figure, after clicking
on P1 Channel 0’s “Direct Signal Connection” text, the drop-down list appeared.
Configure System Hardware Screen Showing Analog I/O Option Cards,
External Connection, P1 Channel Pull-down List for Channel 0
3-2 Configure System Hardware 886994 DaqView & ViewXL User’s Guide