Setting up digital dbks – Measurement Computing DaqView User Manual
Page 20
Setting Up Digital DBKs
Review the applicable DBK section to ensure that the DBK option is physically set as desired. Note that
certain DBKs do not require hardware or software configuration.
Complete the following steps to set up digital DBKs in DaqView.
1. From DaqView’s main screen, pull down the Device menu, and select
“Configure Hardware Settings.”
Selecting Configure Hardware Settings from the Device Pull-down Menu
The Configure System Hardware screen appears, showing the channel assignments.
Configure System Hardware Screen
DBKs typically have a channel address set on the device, by either a switch or a header.
The channel designated in software must agree with the hardware setting. Thus, in step 2
below, Channel 0 will only be used to select a specific DBK when that DBK is physically set
for Channel 0. Refer to the specific DBK section for more information, if needed.
3-4 Configure System Hardware
886994
DaqView & ViewXL User’s Guide