Leprecon LP-X24 Manual v3.2 - Manual (Page 94)

90 Chapter Four Moving Light Programming
LP-X24 and LP-X48 Users Manual
Select Instruments
## [THRU ##] (+ -)
3 #1 Studio Color
4 #1 Technobeam
5 #2 Technobeam
6 #3 Technobeam
2 #1 Studio Spot Selected
Deselected
Out of Cue
Out of Cue
Out of Cue
Clear
2. Press the Clear softkey.
The LP-X displays the Clear Instruments screen.
Clear Instruments
## [THRU ##] Enter
3 #1 Studio Color
4 #1 Technobeam
5 #2 Technobeam
6 #3 Technobeam
2 #1 Studio Spot In Cue
In Cue
Out of Cue
Out of Cue
Out of Cue
3. To clear one instrument, enter its number on the numeric keypad and then press the
Enter key on the keypad.
4. To clear a range of instruments, enter the lowest number in the range on the numeric
keypad, press the Thru key, enter the highest number in the range, and then press
the Enter key on the keypad.
Dowse versus No Dowse Mode
The LP-X provides you two different modes in which to program.
In "Dowse" mode, you only see the lights that are selected that is, the lights that are
actively selected for programming.
In "No Dowse" mode, you see all lights in the look whether they are selected or not.
Toggle between these two modes when you are recording moving lights by pressing the
side wheel.