Leprecon LP-X24 Manual v3.2 - Manual (Page 148)

144 Chapter Nine Chases
LP-X24 and LP-X48 Users Manual
Copy
Edit Playback
Erase Edit Chase Global
PG 01 PB 01 (12)
PG 01 PB 02 (6)
PG 03 PB 06 (28)
2. Using the side wheel or the + (Plus) and – (Minus) keys, select the page and
playback of the scene list that you want to convert to a chase.
3. Press the Chase softkey.
The Chase softkey text changes to Unchse. The line for the page and playback
shows that the scene list has been converted to a chase and sets the chase rate to
the setting of the Chase Rate fader. If the fader is all the way down, the rate will be
15 BPM (beats per minute).
Note that if this scene list was previously chased and then unchased, the LP-X will
remember the chase rate that you originally set and will restore it, regardless of the
position of the Chase Rate fader, when you chase the scene list again.
Copy
Edit Playback
Erase Edit Unchse Global Bkwd
PG 01 PB 01 (12)
PG 01 PB 02 (6) CHASE 15 BPM
PG 03 PB 06 (28)
4. If desired, set the chase to run backwards by pressing the Bkwd softkey.
The softkey text changes to Fwd.
5. Raise the fader for the page and playback to view the chase.
6. To set the rate for the chase, adjust the Rate fader or tap the Tap button.
If you know the rate of the chase (in beats per minute), using the Rate fader is the
easiest way to set the rate.