Leprecon LP-X24 Manual v3.2 - Manual (Page 82)

78 Chapter Three Conventional Light Programming
LP-X24 and LP-X48 Users Manual
Edit Mode
playback & stack select buttons.
Please select a scene to edit using the
2. Press the Select button for the playback repeatedly until you reach the look you
want to edit.
You may press and hold the Minus (-) button and press the Select button for the
playback to move backward through the looks.
The LP-X displays information for that look of the playback. The LP-X copies the look
to the Programmer Fader.
Edit: PG 1 PB 6 Step: 1
Save
Select
Level
Fade
0:00
50
01 02 03 04 05 06 07 08 09 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
FF
3. Raise or lower manual scene faders to add lights to, remove lights from or change
current levels in the look.
For example, match and grab the 50% level on Manual Scene Fader 1 and then
increase it to 100%.
For example, match and grab the 100% level on Manual Scene Fader 2 and then
decrease it to 25%.
For example, match and grab the 0% level on Manual Scene Fader 3 and then
increase it to 50%.
Note that the level changes will be reflected in the Manual Scene Fader LEDs but
may not be visible on stage. Whether or not you see the level changes on stage will
be determined by the level of the Programmer Fader and the levels to which the
lights are set in other active playbacks.