Leprecon LP-X24 Manual v3.2 - Manual (Page 57)

Setup Essentials Chapter Two 53
LP-X24 and LP-X48 Users Manual
assigned to board control channels 1 through 6, even if they were physically wired to
dimmer circuits 101 through 106.
To Create a New Dimmer Patch
1. From the Setup Mode screen, press the Patch softkey.
The Patch List screen appears.
Copy New
Patch List
Default [ACTIVE]
The Default patch is 1:1 with channels 1 through N set to 100% intensity.
The first N channels are mapped, where N is the number of hardware and "virtual"
faders currently 96 (LP-X24) or 192 (LP-X48).
2. Press the New softkey.
Enter a patch name
Name:
Patch 01
Yes / No
3. Using the keypad, enter a name for the patch.
4. Press Yes to proceed or No/Esc to cancel.