Leprecon LP-X24 Manual v3.2 - Manual (Page 163)

Stacks Chapter Ten 159
LP-X24 and LP-X48 Users Manual
4. If desired, specify that you want to insert a blank step by pressing the Blank softkey.
Copy Blank
Insert a blank step
Insert Stack Step
Insert As
1.1
5. To specify the number for the new step, use the left wheel or enter the step number
on the numeric keypad and press the Enter key.
6. When you are ready, press the Yes button.
The LP-X inserts the copied or blank step in the specified position and returns to the
Edit Stack screen.
NOTE: There is another method for inserting a stack step. Create the scene in Record
mode and press the stack select. In the stack step dialog, pick the step number where
you want to insert the look. You can use the same method to copy a step; just load it
using Edit first.
To Delete a Step from a Stack
1. Put the LP-X into the following modes for editing:
Button/Fader Setting
Modes Edit and Stack
Display ML or Dim
Filter ML, Dim or Both
Bump
Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Down (typically zero)
The LP-X displays the Edit Stack screen.