Leprecon LP-X24 Manual v3.2 - Manual (Page 176)

172 Chapter Eleven Moving Light Effects
LP-X24 and LP-X48 Users Manual
Save
Record: PG 1 PB 1 Step: 1
Seq
Rate
0:05.0
Start Delay
0:02.0
Loops
2
Color Effect: Wheel Order
9. Make additional changes to the effect and then save them by pressing the Save
softkey.
For instance, you might want to refine the effect for a specific light without changing
the parameters for the others. Deselect all lights except the one, make the parameter
changes and then press the Save softkey.
To take a light out of an effect completely, hold down the Clear key and then press
the light's ML Select button.
10. When you are done, press the No/Esc button twice to return to the ML Programmer
screen.
The ColrFx softkey display flashes to indicate that there is an effect applied to at
least one of the selected lights.
To Create a Label Chase (Non-Wheel-Order)
Color labels and beam labels have a label chase effect (non-wheel-order).
1. Put the LP-X into the following modes for moving light recording:
Button/Fader Setting
Modes Record and Scene
Display ML
Filter ML
or BOTH
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Up
The LP-X displays the Moving Light Programmer.
2. Select the lights that you want to include in the effect.
See "Selecting Moving Lights for Programming" beginning on page 87 for complete
details about selecting lights.