Guntermann & Drunck CATCenter X systems Operation - Manual (Page 73)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 73
5.3.1 Editing the Selected Target
Open the Edit TARGET submenu of the target selected using the UP ARROW
or DOWN ARROW keys on your keyboard by pressing the F5 key. In this
submenu, you can perform the following tasks:
 Change the target name
 Reset the IVT data of the selected target
 AdonIS synchronization
5.3.1.1 Changing the Target Name
You can modify the default physical target name (ID of the CATpro2; see
Chapter 2.4 ) to a logical target name.
Press the TAB key to enter edit mode for the selected target. The target name
is displayed in white in the header of the Edit TARGET submenu.
Up to 15 alphanumeric characters can be entered.
F2 saves the data and takes you back to the TARGET MANAGEMENT
submenu .
To exit the menu, press ESC .
5.3.1.2 Reset Target Video Data
A profile that contains information regarding the cable parameters (e.g. cable
length) for every target is saved per console. These values ensure the optimal
display of the video at your workstation. These values are determined and
saved automatically the first time your console connects to a target.
If the cable length between a CATpro2 and the CATCenter changes, this may
influence the display quality. The target displayed on your monitor may
become fuzzy or distorted.
In order to automatically create new profiles for all connected consoles the next
time they connect to this target, the stored profiles can be deleted using the
entry Reset target video data.
To do so, use the
UP ARROW and/or DOWN ARROW keys on your keyboard
or the mouse to select the entry Reset target video data and then press
ENTER .