Guntermann & Drunck CATCenter X systems Operation - Manual (Page 115)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 115
Press the
ENTER key to confirm the deletion. Use the ESC key to cancel it.
5.9 Turn Targets On/Off using AdonIS – Required
Configuration
This function is only available if a HardBoot CCX is connected.
In the Power submenu, you have to establish power management settings for
every individual target.
The prerequisites for supplying power to the connected targets are:
 A HardBoot CCX must be connected to the front of the CATCenter via the
RS232 interface.
 In the SYSTEM CONFIG submenu -> RS232 (see Chapter 5.8.5 ),
"HardBoot" has to be entered as the service.
 For all targets the CATCenter is to supply with power, at least one
HardBoot must also be connected to the CATCenter. If a CATCenter slave
is connected to the CATCenter master and the targets connected to this
slave are to be supplied with power, a HardBoot to supply power to these
targets must be connected to the CATCenter slave!
If you have established all settings for each target available on the CATCenter,
you can use the function TARGET POWER (operation menu, see
Chapter 3.9 )
to turn the power of the respective target selected in the SELECT menu on or
off.
Up to three power sources can be connected for every target.
Proceed as follows for the configuration:
In the CONFIGURATION menu, use the arrow keys to select the menu item
POWER.
C o n f i r m
Do you really want to reset
all netfilter rules?
Your personal settings will
be lost and set to default
rules to access the system.
ESC: Cancel
Enter: OK