Guntermann & Drunck CATCenter X systems Operation - Manual (Page 33)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 33
3.8 Displaying Additional Target Information
In the TARGET INFO line, you can determine what additional target
information is displayed in the right-hand column of the Select menu.
The following entries are available:
 Off No additional information is displayed.
 SelectKey The SelectKey established to access the respective
target is displayed (this is editable, see
Chapter
4.4 ).
 ID The physical target name (ID of the CATpro2; see
Chapter 2.4 ) can be displayed.
To change the entries, carry out the following steps:
1. Access AdonIS by pressing the key combination (default): CTRL +
NUM
2. Access the OPERATION menu by pressing the F9 key.
3. Move the cursor to the entry TARGET INFO and press the Spacebar
key or the H key.
Alternatively, the function can be called from the SELECT menu using the
hotkey combination
CTRL + H .
Now you can switch between the individual entries, which are shown with a
yellow background, using the toggle key (
Spacebar ). Use the ESC key to exit
this menu and return to the SELECT menu. All settings that were modified are
saved.
3.9 Turn Target On/Off using AdonIS
This function is only available if a HardBoot CCX is connected.
In the row "TARGET POWER", you can turn the currently active target on or
off.
The base requirements for this function are:
 At least one HardBoot must be connected to the CATCenter to supply
power.
 The corresponding settings have to be established in the "CONFIG
menu -> Power" for this target (see Chapter 5.9 )